This Assessment is to assess your existing knowledge prior to taking the course.
Click the button below to start.
Question 1 of 10
Direct Current (DC) is a the flow of?
Protons which travel in one direction only
Electrons which travel in one direction only
Photons which can travel in both directions
Electrons which can travel in both directions
Question 2 of 10
Canbus wires fitted to a vehicle are typically twisted to?
Increase the cables rigidity
Help reduce signal interference
To maintain heating of the cables
To reduce the resistance of the cables
Question 3 of 10
In which location must a GPS antenna be installed?
Positioned as near to the GPS device as possible
On a vertical flat surface
With its direction position towards the drivers seat
With an uninterrupted view of the sky
Question 4 of 10
In the case of any conflict when complying with installation instructions, which guidance should take priority?
The equipment manufacturer
The wiring manufacturer
The Vehicle Manufacturer
The vehicle dealer
Question 5 of 10
Where a relay has contacts labelled 30, 85, 86 ,87 and 87a, which type of relay will it be typically referred to?
Single Pole, Double Throw
Single Pole, Single throw
Double Pole, Double Throw
Double Pole, Single Throw
Question 6 of 10
Before drilling any hole in a vehicles body, the technician should carry out which of these action initially?
Check the other side of the panel for any component(s) that could be damaged
Check that the drill has sufficient power to drill the hole
Use a volt meter on the panel to check there are no voltages going through the panel to be drilled
Check the drill bit to see that it is sharp enough
Question 7 of 10
The Nominal Voltage of each cell on a conventional Lead/Acid battery is?
2.1 Volts
6.2 Volts
4.2 Volts
1.8 Volts
Question 8 of 10
A typical "Mild" Hybrid Vehicle will have?
Both a 12 volt and a 48 volt battery
A single battery of at least 100 volts
Two 12 Volt batteries connected in parallel
Both a 6 Volt and a 24 volt battery
Question 9 of 10
What is the main function of fleece tape as shown in the photograph?
As a First Aid dressing
To insulate a soldered connection
For looming under the bonnet of the vehicle
As a material used for anti-vibration purposes
Question 10 of 10
See the attached relay diagram.
Indicate in the space below, which connections corresponds to all the numbers on the relay.